最后更新:2022-08-04 15:46:22 手机定位技术交流文章
目录
一、交换机端口镜像
1.1分类
1.2 基本概念
1.3 目的
1.4 功能
1.5 实验
在一台交换机上
2.远程端口镜像
将交换机A的某接口数据镜像到交换机B的某接口上
从一个或多个源端口传输数据到指定端口
协助分析一个或多个网络接口流量(IDS入侵检测设备)
通过将流量镜带到端口来分析流量
流量备份,故障分析,流量备份
当PC1访问PC3时,PC2接收数据流,当PC1映射开关接口F0/5到开关接口F0/2时,可以接收PC1的流
交换机上配置
SW1(config)#monitor ?
event-trace Tracing of system events
session Configure a SPAN session
SW1(config)#monitor session ?
<1-2> SPAN session number
SW1(config)#monitor session 1 ?
destination SPAN destination interface or VLAN
filter SPAN filter VLAN
source SPAN source interface or VLAN
SW1(config)#monitor session 1 source ?
interface SPAN source interface
vlan SPAN source VLAN
SW1(config)#monitor session 1 source int f0/5 ?
, Specify another range of interfaces
- Specify a range of interfaces
both Monitor received and transmitted traffic
rx Monitor received traffic only
tx Monitor transmitted traffic only
<cr>
SW1(config)#monitor session 1 source int f0/5 both
SW1(config)#monitor session 1 d
SW1(config)#monitor session 1 destination int f0/9
使用PC1 ping PC3来抓进F0/2
在实体机上配置
使用相同的操作配置xshell连接开关
本文由 在线网速测试 整理编辑,转载请注明出处 。